Over the years, Multotec has developed a wide range of superior quality classification cyclones. Each Multotec cyclone application is sized for duty, so you can choose from small to large diameter or from special application hydrocyclones that will provide you with optimal classification and plenty of operating flexibility.
Classification Cyclones
1
High Efficiency Scrolled Evolute Inlet Head Design
2
High Capacity Cyclones
3
Wear-Resistant Lining Options for Longer Wear Life
4
Weep Holes to Prevent Damage to Housings
High Capacity Classification Cyclones
Multotec has developed a range of high capacity classification cyclone manufactured in mild steel and lined with rubber or ceramic. Cyclones components are interchangeable, resulting in costs-saving by replacing worn component only or optimizing circuit performance at minimal costs.
Learn more
Fine Classification Cyclones
Multotec developed the VV Cyclone Range to offer cost effective solutions for applications requiring a finer cutpoint, usually between 10 to 50 microns. These cyclones are regularly found in grinding circuits, de-sliming and dewatering steps.
Learn more
Extra-Fine Classification and Dewatering Cyclones
Multotec specializes in extra-fine industrial classification applications with its FC Cyclone Range. FC cyclones are used in applications where a cut-point below 10 microns is required, such as in critical de-sliming steps. They operate at high inlet
pressures and are installed in a canister or distributor arrangement.
Learn more
Special Applications
Multotec has successfully worked on and installed various cyclone designs in applications where conventional cyclones would offer a less effective solution.
Learn more
Cyclone Clusters and Pulp Distributors
Multotec offers compact and layout-friendly cyclone clusters and manifolds in different designs and arrangements.
Learn more
Dense Media Separation Cyclones (DMS Cyclone or DMC)
Dense media separation has been gaining interest in the last few years as a cost-effective solution to pre-concentration and mineral recovery when coarsely liberated particles are of different specific gravities.
No DMS technology has shown better process and commercial efficiency than cyclones in pre-concentrating ore or recovering minerals or gems of value. Multotec has been a pioneer and leader in DMS cyclone development, improvement and supply. Because of this, we have gained the trust of the diamond industry by consistently delivering equipment attaining expectations and achieving maximum processing efficiency.
Other applications in coal and heavy minerals have been designed in the last 40 years to enrich the ore early in the process and increase production.
1
Scrolled Evolute Inlet Head
2
High Efficiency with Low Ep Values
3
Inlet Design
4
Mono Cone Option for Reduced Turbulence
5
Wear-Resistant Lining Material
MAX DMS Cyclone Range
Initially specifically designed for the coal industry, the MAX range was started with large diameter cyclones to accommodate large material top sizes as well as ever-increasing flow rates.
Learn more
Cast Iron DMS Cyclone Range
These cyclones are proudly manufactured in Canada, from 27% chrome cast iron and withstand the high abrasion and wear that can be caused by coarse hard ore.
Learn more